A porous surface.
Untreated concrete has pathways that allow moisture to enter. Protecting the surface is only part of the job.
Hard-working farms.
Lasting protection.
Internal treatment and surface protection for the concrete your farm depends on.
Explore products
AgriCrete concrete preservationDiscover the two-product system
Good protection
goes below the surface.
Concrete is porous. Water and contaminants can enter beneath the surface. The AgriCrete two-product system pairs an internal treatment with a water-repellent finish.
Treat from within.
The internal treatment penetrates the concrete and reacts within it to form insoluble silicate crystals.
Explore internal protectionFinish at the surface.
After the internal treatment has cured, PTS+ adds a water-repellent finish. Two complementary treatments, one concrete preservation system.
Read how the system works
The right treatment.
For the job at hand.
Start with your surface. Explore the product details, then check the technical and application documents.
Acid resistance testing.
See the difference.
Three concrete samples. 25 applications of muriatic acid. Compare untreated concrete, internal treatment and the complete two-product system in our published demonstration.
Untreated concrete
No protective treatment
Internal treatment
PIM+ Type S
Complete system
PIM+ Type S + PTS+
Before you begin.
What is the AgriCrete two-product system?
The AgriCrete two-product system combines PIM+ or PIM+ Type S, which treats the concrete internally, with PTS+, a water-repellent surface treatment. The products address different parts of concrete protection.
Which product is applied first?
PIM+ or PIM+ Type S is applied first. PTS+ follows after the internal treatment has cured. Surface preparation, coverage and curing requirements are detailed in the application instructions for each product.
Where can I find technical and safety information?
Each product page provides its technical data sheet, safety data sheet and application instructions. Review the current documents and discuss your substrate and site conditions with the technical team before application.
Put your concrete to work.
Tell us about your concrete, your conditions and your project.